Jun 20, 2020

There are balance weights on the new wheels, indicating that the wheel quality is not good?

Leave a message

In the state of a new car, it is found that there is a positioning block on the front wheel. This positioning block should be called the balance block of the wheel accurately. Its function is to keep the stability of the wheel when the wheel rotates at high speed, so that the car can be driven at high speed. It can be relatively stable and avoid jitter. So for the subject of the subject, the balance weight was found in the state of the new car. Is this normal? Let's discuss briefly below.

According to my own observation, in some older models, the balance weight is on the outside of the wheel hub, and you can see that many new cars are equipped with it. In the new car from the rear, the balance weight of the wheel is installed on the inner side of the hub, which cannot be easily seen from the outside, but through the hole in the hub or when the wheel is removed, you can see the square balance weight inside the hub. , So for these balance weights on the wheels, are they abnormal when new cars have them?

What I want to say is that this is a normal situation, because a car’s wheel consists of two parts, one part is the hub, and the tires on the outside of the hub. If the hub wants to be completely balanced, there is no problem, after all, it is rigid. It’s almost possible to control the tolerance of the mold and the material to achieve a balance; but the outer wheel is a rubber product, and there are some cotton threads or steel wires in the rubber. When these materials are mixed together, it is difficult to achieve the balance weight. More balanced.

When the hub and the wheel are assembled together, the two factors are superimposed, and there will be a double uncertainty. Therefore, it is more difficult to achieve a complete balance of the new wheel and the new wheel. Therefore, when assembling the wheels of a new car, after completing the assembly of the wheels and hubs, it must be dynamically balanced, and then installed on the car after the dynamic balance is completed, so that the vehicle can run more smoothly.

I once repaired a tire outside. Because it is a relatively remote small town, there are only tire repair patches and no dynamic balancer. After the tire repair is completed, I will load the car and continue on the road. At first, there is no feeling at low speed. , I feel as if nothing has happened, and when the vehicle speed exceeds 100km/h, I feel that the repaired wheel (the left front wheel) begins to shake, and it shakes until 130km/h. When it exceeds 130km/h, it seems to shake again. A little bit smaller, I think it should exceed the resonance frequency, and the speed range of 100km/h~130km/h is within the frequency of wheel shaking, so it will shake particularly badly in the speed range of the car.

All in all, the situation of installing dynamic balance weights on new cars is normal in my opinion, because wheels, especially wheels, cannot be completely balanced, even for new cars. A certain amount of dynamic balance weights are needed to make the wheels. Maintain a relative stability to improve driving stability.


Send Inquiry